AG Neovo F-419 Bedienungsanleitung

F-41919" TFT LCD PANEL

9OSD Transparency 1. This function let's you set the transparency of the OSD menu. The transparency is adjustable from 0 to 10. 11 scales are

10Selecting a Color Temperature setting The following conditions are recommended for the available settings: Setting Use 9300K General Use 6500K

11 Troubleshooting This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing differences among various VGA cards

12LCD Panel Display Technical Features and Specifications Screen Size 19" (48cm) diagonal Panel Pixel Format 1280 x 1024 vertical strip Mon

13Interface Frequency The following frequency range is the working period. If the entered mode between below period but not match the frequency of su

14Supported Timing List If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing. T

15 TIMING FH(KHZ)FV(HZ)SYNC POLARITYTOTAL(DOT/LINE)ACTIVE (DOT /LINE) SYNC WIDTH(DOT/LINE) FRONT PORCH(DOT/ LINE) BACK PORCH (DOT/LINE)PIXEL F

16 Regulations FCC compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this dev

17 TCO'99 Congratulations! You have just purchased a TCO'99 approved and labeled product! Your choice has provided you with a product deve

18Fax: +46 8 782 92 07 Email (Internet): [email protected] Current information regarding TCO'99 approved and labeled products may also be obtai

Table of Content Precautions ...

2Precautions Installation • Do not cover or block the ventilation ports on the rear of the monitor. • Do not install the monitor close to heat source

3• Do not insert objects or spill liquids into the ventilation ports on the monitor’s rear, as fire, electric shock, and/or unit failure may result.

4Installing and Removing the Base To attach the base to the monitor, do the following: When you open the packing carton, remove the LCD monitor base,

5Identifying parts and controls The center front panel of the monitor carries the control array. FRONT VIEW The controls are, from left to right:

6Setup Follow these directions to correctly set up your monitor. 1. Remove all packing materials and wrapping from the monitor 2. Place the monitor

7Note: The monitor is compliant with VESA FPMPMI standards and can be wall- or arm-mounted. Before wall-mounting or arm-mounting, please disassemble

8Customizing your Monitor The On Screen Display (OSD) system provides a full range of customizable tools to optimize your display. Important: While f